Closer View

The TechPress 2™ hydraulic-pneumatic automatic mounting press is used to encapsulate samples for metallographic preparation. The microprocessor based system allows up to 50 mounting steps to be programmed, including cycle start/stop, preheating time and temperature, heating time and temperature, predefined mold pressures or manual pressure control and cooling time. Temperature is displayed in both Fahrenheit and Celsius throughout the mounting procedure.

Two mounts can be produced at one time using the duplexing spacer. Depending on mold size, cycle times range from 7-12 minutes. An audible alarm signals cycle completion.

Mold assemblies are sold separately and come with a duplexing spacer.

Features:

• Prepare up to 2 mounts in 7 minutes
• Touch-pad switches control all functions
• Stores up to 99 mold programs
• Backlit LCD display
• Interchangeable mold assemblies from 25mm through 2 inch, includes a duplexing spacer, allowing up to two mounts per cycle
• Programmable up to 50 mounting steps including cycle start/stop, preheat/heating time and temperature, cooling time and pressure
• Impact, corrosion and heat-resistant cover
• Visual and audible cycle completion alarm
• Bayonet cap with non-heat conducting handles that remain cool during operation
• Large heat-sink/holding tray to remove remaining heat from bayonet cap/die
• Password protectable menus
• Heating power: 1500 W
• Molding pressure: up to 5500 psi/379 Bar
• Preheat/molding temp: 0-200ºC/32-392ºF
• Preheat/molding time: 0-60 minutes
• Cooling time: 0-60 minutes
• Dimensions: 18" W x 22" D x 28" H (457 x 559 x 711 mm)
• Weight: 98 lb. (45 kg)
• Two (2) year warranty - parts and labor
• Designed & Manufactured by Allied in the USA

Closer View